Outputs NC program for MDI operation to CNC.
Universal Fanuc Driver
Fanuc Focas Library CD
Specify the library handle. See "Library handle" for details.
Specify the number of characters of NC program to be written.
|Series 15||1 ,.., 199|
|Series 15i||1 ,.., 255|
|Series 16/18/21, 16i/18i/21i, 0i-A/B/C||1 ,.., 470|
|Series 30i, 0i-D/F, PMi-A||1 ,.., 500|
|Power Mate i||1 ,.., 500|
|Series 16i/18i-W||1 ,.., 472|
Specify the top address of NC program data.
EW_OK is returned on successful completion, otherwise any value except EW_OK is returned.
The major error codes are as follows.
|Return code||Meaning/Error handling|
Series 16/18/21, 16i/18i/21i, 0i-A/B/C, Power Mate i
Length of the block (length) is illegal.
A character which is unavailable for CNC program is detected.
The extended driver/library function is necessary.
Set CNC mode to MDI.
MDI operation in progress
As for the other return codes or the details, see "Return status of Data window function"
For HSSB connection,
For Ethernet connection,
The Ethernet function and the extended driver/library function are necessary. However, in case of Series 16i/18i/21i-B, 0i-B/C/D/F, Series 30i and PMi-A, the required CNC option is as follows. When Embedded Ethernet is used,
above two optional functions are not required.
The Ethernet function and the extended driver/library function are necessary.
However, in case of Series 16i/18i/21i-B, 0i-B/C/D/F, Series 30i and PMi-A, the required CNC option is as follows.
When Embedded Ethernet is used,
When Ethernet board is used,
- only Ethernet function is required.
This function is related to the following CNC parameter.
See the manual of CNC parameter for details.
3203# = 1 (must be set)
|P (Punch press)||-|
|Power Mate i-D|
|Power Mate i-H|
|Power Motion i-A||O|
|"O"||:||Both Ethernet and HSSB|
|"X"||:||Cannot be used|
Note) 0i-C does not support the HSSB function.