Requests CNC to start verification of NC program.
(This function must be executed before cnc_verify/cnc_cverify.)
It is possible to compare already registered NC program in CNC and a program which is output by the application program.
The procedure of verify is as follows.
Universal Fanuc Driver
Fanuc Focas Library CD
Specify the library handle. See "Library handle" for details.
EW_OK is returned on successful completion, otherwise any value except EW_OK is returned.
The major error codes are as follows.
|Return code||Meaning/Error handling|
As for the other return codes or the details, see "Return status of Data window function"
For HSSB connection,
For Ethernet connection,
The Ethernet function and the extended driver/library function are necessary. However, in case of Series 16i/18i/21i-B, 0i-B/C/F and 30i, the required CNC option is as follows. When Embedded Ethernet is used,
above two optional functions are not required.
The Ethernet function and the extended driver/library function are necessary.
However, in case of Series 16i/18i/21i-B, 0i-B/C/F and 30i, the required CNC option is as follows.
When Embedded Ethernet is used,
When Ethernet board is used,
- only Ethernet function is required.
This function is related to the following CNC parameter.
See the manual of CNC parameter for details.
0022=16(except EDIT mode) (must be set) (At HSSB connection)
0020=7 (EDIT mode) (must be set) (At Ethernet connection)
0022=7 (except EDIT mode) (must be set) (At Ethernet connection)
|P (Punch press)||-|
|Power Mate i-D|
|Power Mate i-H|
|Power Motion i-A||H|
|"O"||:||Both Ethernet and HSSB|
|"X"||:||Cannot be used|
Note) 0i-C does not support the HSSB function.
cnc_verify cnc_cverify cnc_vrfend