HEIDENHAIN TOOLS & DRIVERS UPDATE | NEWS

TOP

During May 2021 we released completely redesigned versions of our tools and drivers for data acquisition from machines with Heidenhain controllers and its output to Business Information Systems, Databases, MTConnect and OPC UA.

Major Enhancements

• The most recent versions of NCK based TNC 320, 620 and 640 devices are fully supported
• Access to areas protected by a password or code number is now supported on a per-machine basis
• PLC data is now output according to the automatically detected controller type.
• Network connectivity to your controller is checked before querying data
• Detection of TNC errors and output in understandable form was enhanced
• Execution speed is now 10 times faster than in the previous versions

Heidenhain Device Driver

Enables simultaneous reading and output of data from up to 54 controllers per CNCnetPDM software instance:
https://www.inventcom.net/support/heidenhain/tnc-device-driver

Upgrade Instructions:
https://www.inventcom.net/support/heidenhain/tnc-device-driver#UPGRADE

Read & Write Heidenhain PLC Data

Allows writing and reading of single machine parameters or PLC values from different areas:
https://www.inventcom.net/support/heidenhain/write-tnc-plc-data

Read Heidenhain PLC Data

Reads PLC data from selectable areas and enables to scan for target values:
https://www.inventcom.net/support/heidenhain/read-tnc-plc-data

Heidenhain TNC Machine Data

Acquires typical machine data and outputs PLC data according to the controller type detected:
https://www.inventcom.net/support/heidenhain/tnc-machine-data

Release Notes for all programs and drivers:
https://www.inventcom.net/support/heidenhain/release-notes

For all drivers and programs cost free time-limited licenses are available, please contact us if you have any questions!

Privacy notice

This website uses cookies. By continuing to use it you agree to our privacy policy.