News CNCnetPDM About us Support  
         
  

DEVICE STATES | CNCNETCONTROL MANUAL

The icons and status text (1) for configured devices changes according to their state:

Device states in CNCnetControl

FIG 1:  Device states in CNCnetControl
  • Green icon, device is connected, status shows ‘Connected’
  • Red icon, device is disconnected or unreachable, status shows ‘Disconnected’
  • Yellow icon, device is manually switched off, status shows ‘Switched Off’
  • Blue icon, device is currently communicating with CNCnetPDM. Status shows ‘Communicate’ TOP

Privacy notice

This website uses cookies. By continuing to use it you agree to our privacy policy. 

https://www.inventcom.net/support/cncnetcontrol-manual/device-states
Support | CNCnetControl Manual | Overview
CNCnetControl is a Graphical User Interface (GUI) to monitor and configure CNCnetPDM running on a local or remote PC. Double clicking CNCnetControl.exe opens up a dialog with... [read more]
Overview
Support | CNCnetControl Manual | Device Data
According to the items selected for data acquisition in CNCnetPDM.ini the right lower pane shows incoming data (1) from the devices. If all collectable items are selected output... [read more]
Device Data
Support | CNCnetControl Manual | Close Open Device
Clicking (1) on one of the devices in the left window enables the buttons in section ‘Device’. Instead of ‘Device’ the number and name of the selected... [read more]
Close Open Device
Support | CNCnetControl Manual | Connect to Service
Clicking on button ‘Connect’ in section ‘Service’ enables you to connect CNCnetControl to a CNCnetPDM program or service on a remote or the local PC. A... [read more]
Connect to Service
Support | CNCnetControl Manual | Manage Service
Clicking on button ‘Manage’ in section ‘Service’ also opens a dialog window that enables you to select a PC and/or an instance of CNCnetPDM, see chapter... [read more]
Manage Service
Support | CNCnetControl Manual | Adjust Protocol Level
For debugging purposes ( only! ) it can be useful to increase the level of writing information about program activities to the log file directory. Clicking on button ‘Set... [read more]
Adjust Protocol Level
Support | CNCnetControl Manual | Set or Adjust Device Parameters
CNCnetControl enables you to set or change writable variables or parameters at a selected controller. To do so you have to first select a device in the left pane of the... [read more]
Set or Adjust Device Parameters
Support | CNCnetControl Manual | Close Open Database Connection
If the currently selected program, service or instance of CNCnetPDM is connected to a database you see an animated green traffic light icon in section ‘Database’... [read more]
Close Open Database Connection
Modified: 2018-01-12